Engine noise! Need help!
Re: Engine noise! Need help!
Similar subject, how do i remove the two needle bearings in the clutch cover? are the pressed in. Also i can't find the needle baring part numbers on any diagram. Please help.
Re: Engine noise! Need help!
Heat should help to pull out the bearings. E.g. remove everything of plastic and rubber and put the clutch cover into a oven.
I doubt that Honda ever sold these bearings separately so there is probably no part number that could help. Means you need to get new bearings by their dimensions or slaughter good bearings from a smashed cover by the proven "cut everything recklessly except the bearing" method in case the heat removal method turned out critical.
Mounting the bearings without damaging them may require some heat again.
Sorry, I see no simple solution.
I doubt that Honda ever sold these bearings separately so there is probably no part number that could help. Means you need to get new bearings by their dimensions or slaughter good bearings from a smashed cover by the proven "cut everything recklessly except the bearing" method in case the heat removal method turned out critical.
Mounting the bearings without damaging them may require some heat again.
Sorry, I see no simple solution.
Cosky's great (free) online manual: http://cosky0.tripod.com
forum links to common technical issues
If you really like this site and you would not like to see it vanish soon, have a look there: Urgent: Future of HondaCB650.com Forum
forum links to common technical issues
If you really like this site and you would not like to see it vanish soon, have a look there: Urgent: Future of HondaCB650.com Forum
Return to “Technical Discussion”
Who is online
Users browsing this forum: No registered users and 56 guests